eblis 发表于 2012-5-30 20:40:26

完蛋，WVL买了2天改机就改城砖了

开机开不了，电源灯一直闪，闪完就是错误灯一直闪，每次6下
什么方法都试过了，硬盘也拿下来重新格了，也换过硬盘，都没用，电脑就是发现不了NAS
看了很多改机得教程，也搜了很多次，没见谁改机改成砖的啊
有没有朋友遇到过这种情况？

c1235 发表于 2012-5-30 21:05:17

试试能不能进EM模式重刷固件

eblis 发表于 2012-5-30 23:17:53

c1235 发表于 2012-5-30 21:05 static/image/common/back.gif
试试能不能进EM模式重刷固件

请问要怎么进EM模式？进去然后怎么做？我找了一下好像没有类似得方法

pt880 发表于 2012-5-31 10:14:16

eblis 发表于 2012-5-30 23:17 static/image/common/back.gif
请问要怎么进EM模式？进去然后怎么做？我找了一下好像没有类似得方法

LinkStation (LS-CHL, LS-XHL LS-VL , LS-WTGL and LS-WXL, LS WVL)
NOTE: The FUNCTION button for the LS-CHL and LS-XHL series is located on the front of the NAS whereas the LS-WTGL has the FUNC button on the back.
         1. Make sure that your NAS is powered off
         2. Hold down the FUNC/FUNCTION button for at least 6 seconds before powering the NAS on (LS-CHL and LS-XHL have their function button on the front whereas the LS-WTGL and LS-WXL have theirs on the back)
         3. While continuing to hold down the FUNC/FUNCTION button power the NAS on
            At this point it varies for these units so please read carefully:
                * LS-CHL and : The FUNCTION button will start blinking at which point you release the button and hold it down for an additional 10 seconds or until the FUNCTION button goes solid. At this point you may release the FUNCTION button
                * LS-WTGL and : The POWER light on the front of the unit will begin blinking blue rapidly at which point you may release the FUNC button. The POWER light should turn green in approximately 60 seconds
                * LS-XHL, LS-WXL, LS-VL and LS- WVL : These units do not have any procedure to boot into EM mode. The unit will automatically boot into EM mode if it needs to. If the unit is not booting at all you need to follow the TFTP boot procedure for the LS-XHL and LS-WXL. At the moment the LS-VL and LS-WVL units do not have a TFTP boot program and a fix is being worked on.
NOTE: If you still don't see the device on the NAS Navigator after 120 seconds, then I would suggest performing a TFTP boot.
   1. Once the NAS shows up on the NAS Navigator you may attempt to access your data or re-flash the firmware

momo 发表于 2012-5-31 13:18:37

打buffalo的售后热线吧，可以直接换新机。你就直接说机器开不到机了。

bgtzhang 发表于 2012-6-7 15:53:00

其实你可以在官网下载最新固件试试，只要能找到NAS，就还有希望。换是没有问题的，但是麻烦点

哇哈哈 发表于 2012-6-7 16:16:10

直接换新机，又可以重新折腾，多爽

TaoEric 发表于 2012-8-27 17:21:49

楼主说说看后来怎么解决的？
页: [1]
查看完整版本: 完蛋，WVL买了2天改机就改城砖了